Attach the Access Point to a Pole Using the KT-147407-02 Pole Part

Before you begin

If 1-axis tilt is not required, you can use the pole part of the KT-147407-02 bracket for pole installation.

The following hardware is required:
  • KT-147407-02 pole part
  • Two 0.5 in. (12.7 mm) wide stainless-steel cable clamps
  • Access point
  • Four M6 hex-head screws

Procedure

  1. Attach the KT-147407-02 pole part to the access point using four M6 hex-head screws.
    Use the semi-circular cuts on the pole part of the KT-147407-02 bracket to attach the screws.
    Click to expand in new window
    Semi-circular cuts on the pole part of the KT-147407-02 bracket
    Image of the KT-147407-02 pole part with the semi-circular cuts
    Callout Description
    1 Semi-circular cuts on the pole part of the KT-147407-02 bracket, used for attaching the M6 hex-head screws.
  2. Insert the 0.5 in. (12.7 mm) wide stainless-steel cable clamp through the long slots on the sides of KT-147407-02 pole part.
  3. Position and insert the ends of the cable clamps around the pole.
  4. Tighten the clamp screws to a torque of 11 in-lbs.