Before you begin
The KT-150173-01 extension arm is used to install the access point on a flat surface,
away from any obstruction and to get a stronger antenna signal.
The following hardware is required:
- KT-150173-01 extension arm
- Eight M6 hex-head screws
- Four M6 hex-head
screws to attach one end of the extension arm to the access
point
- Four M6 hex-head
screws to attach the other end of the extension arm to the wall
- Access point
Procedure
-
Using the KT-150173-01 extension
arm as a template, mark and drill four hole centers on a flat surface.
The holes must be within the
semi-circular cuts of the extension arm.
-
Using four M6 hex-head screws,
attach one end of the KT-150173-01 extension arm to the access point.
-
Using four M6 hex-head screws,
attach the other end of the KT-150173-01 extension arm to the wall.
Tip
The best practice is to use screw-in anchors with the M6 screws
on a wood surface, and concrete anchors on a concrete surface.
