Attach the Access Point to a Pole Using All Three KT-147407-02 Bracket Parts

Before you begin

The following hardware is required to mount the access point on to a pole:
  • KT-147407-02 flat part
  • KT-147407-02 1-axis tilt part
  • KT-147407-02 pole part
  • Access point
  • Four M6 hex-head screws
  • Two hex-head M12 stainless-steel screws and nuts
  • Two 0.5 in. (12.7 mm) wide stainless-steel cable clamps

About this task

To attach the access point to a pole:

Procedure

  1. Attach the flat part and the 1-axis tilt part of the KT-147407-02 bracket to the access point.
    For instructions on how to attach the bracket parts, see Install the Access Point to a Flat Surface Using KT-147407-02 Flat Part and 1-Axis Tilt Part.
  2. Attach the pole part to the 1-axis tilt part using two M12 bolts through the large bracket holes on the 1-axis tilt part and the pole part.
    Click to expand in new window
    Large bracket holes on the 1-axis tilt part of KT-147407-02 bracket
    Image of the 1-axis tilt part with the large bracket holes for attaching the M12 screws
    Callout Description
    1 Large bracket holes used for attaching the M12 screws on the 1-axis tilt part of the KT-147407-02 bracket
    Click to expand in new window
    Large bracket holes on the pole part of the KT-147407-02 bracket
    Image of the pole part with the large bracket holes for attaching the M12 screws
    Callout Description
    1 Large bracket holes used for attaching the M12 screws on the pole part of the KT-147407-02 bracket
  3. Fasten the M12 screws using two M12 hex nuts.
  4. Insert the 0.5 in. (12.7 mm) wide stainless-steel cable clamps through the long slots on the sides of pole bracket.
    Click to expand in new window
    Long slots on the pole part of the KT-147407-02 bracket
    Image of the pole part with the long slots
    Callout Description
    1 Long slots on the sides of the pole part of the KT-1474017-02 bracket. These slots are used to insert the 0.5 in. (12.7 mm) wide stainless-steel cable clamps.
  5. Position and insert the ends of the cable clamps around the pole.
  6. Tighten the clamp screws to a torque of 11 in-lbs.
9036418-03 Rev AA