Move the gland cap, gland cage,
and the gland gasket at least 6 in. away from the LAN cable and the gland
area.
Use a thin, strong, and
non-conductive tool like a flat-bladed orange stick to reach into the gland, and
press down the plastic locking latch of the RJ45 connector.
Warning
Ensure that
you do not touch any components on the PCBA board near the gland
area.
While pressing down the plastic locking latch on the RJ45 connector, gently
pull the LAN wire to take the connector out of the access point.
Remove the gland cap, gland
cage, and the gland gasket from the LAN cable.
Repeat the same process on GE2
connection, if necessary.
