In the Device RADIUS
Authentication Parameters field,
Set a NAS-Identifier Attribute up to 253 characters in
length.
This is the RADIUS NAS-Identifier attribute that typically identifies
where a RADIUS message originates.
Set a NAS-Port-Id Attribute up to 253 characters in
length.
This is the RADIUS NAS port ID attribute which identifies the device
port where a RADIUS message originates.
In the LEDs (Light Emitting
Diodes) field, select one of the following Turn on
LEDsoption: to enable the LEDs on an access point.
Off (0) - select to disable LEDs on the access point.
On (1) - select to enable LEDs on an access point.
Note
This is the default setting.
Flash Pattern (2) - to enable the access point to blink in a manner
different from its operational LED behavior.
Note
Enabling this option allows an administrator to validate that the
access point has received its configuration from its managing
controller during staging. In the staging process, the
administrator adopts the access point to a staging controller to
get an initial configuration before the access point is deployed
at its intended location. Once the access point has received its
initial configuration, its LED blinks in a unique pattern to
indicate the initial configuration is complete.
In the MeshConnex
field, use the Root Path Monitor
Interval option to configure the interval (from 1 - 65,535
seconds) to monitor the path to the root node. This value specifies how often to
check if the mesh point is up or down.
In the RADIUS Dynamic
Authorization section, set the Additional Port
value to enable a Cisco (Identity Services Engine) AAA (Authentication,
Authorization and Accounting) server to dynamically authenticate a
client.
Set this value to 1700. The allowed port range is 1 to 65,535.
When a client device requests access to the network, the Cisco ISE RADIUS
server presents the client with a URL where a device‘s compliance is checked
for definition file validity (this form of file validity checking is called
posture). The check verifies, for example, that the
device's anti-virus or anti-spyware software is valid. If the device
complies, it is allowed access to the network.
Click OK to save the
changes made to the profile's advanced miscellaneous configuration.
Click Reset to revert to the last saved configuration.
