To override the critical resource monitoring interval
configuration:
Procedure
Select the Monitor Interval
tab.
Critical Resources
Screen - Monitor Interval Tab
Use Monitor Interval
screen to set the duration, in seconds, between two successive pings to the
critical resource.
Select a duration between 5 and 86,400 seconds. The default setting is 30
seconds.
Use Source IP for Port-Limited
Monitoring to define the IP address used as the source address
in ARP packets used to detect a critical resource on a layer 2 interface.
Generally, the source address 0.0.0.0 is used in the ARP packets used to
detect critical resources. However, some devices do not support that IP
address and drop the ARP packets. Use this field to provide an IP address
specifically used for this purpose. The IP address used for Port-Limited
Monitoring must be different from the IP address configured on the
device.
Use Monitor Retry
Count to set the number of retry connection attempts (1 - 10)
permitted before this device connection is defined as down (offline).
The default setting is three connection attempts.
Click OK to save the
and monitor interval changes.
Click Reset to revert to the last saved configuration.
