Installing a QSFP+ or QSFP28 Module

You can install or remove QSFP modules in your switch without powering off the system.

Warning

QSFP modules contain Class 1M lasers. Invisible laser radiation can occur when laser connections are unplugged. Do not stare into the beam. This device is compliant with IEC 60825-1 Amendment 2 and CFR21Section 1040.

Remove the QSFP module from its antistatic container and remove the dust covers from the module optical connector.

If your module has a protective pad covering the card-edge connector, remove it. Store the antistatic container, dust covers, and card-edge connector protective pad in a clean location from which they can be easily retrieved if you need to uninstall the module.
Remove any rubber dust covers from the port where you are installing the QSFP module.
Holding the QSFP module by its sides, insert the QSFP module into the port on the switch or module (see Installing a QSFP Module (ExtremeSwitching, Summit, and 8000 Series Switches)).

Installing a QSFP Module (ExtremeSwitching, Summit, and 8000 Series Switches)
Slide the QSFP module into the port until you hear it click into place.
Push up on the handle to secure the QSFP module in the switch (see Installed QSFP Module).

Installed QSFP Module

If you are installing only one QSFP module, make sure that all unoccupied ports are covered with a rubber dust cover, which is shipped with the Summit option card or BlackDiamond I/O module.