Part number: 10330
The CFP2 LR4 is an optic transceiver for 100 Gb Ethernet applications.
The module supports 100 Gigabit data rate that can reach up to 10 kilometers over standard single-mode fiber (G.652). Data is transmitted using four 25 Gigabit data lanes. The CFP2 LR4 module uses an LC connector.
The CFP2 LR4 module is supported in the BlackDiamond X series switch.
For a complete listing of hardware compatible with these modules, see the Extreme Optics Compatibility website.
Transmission distances are provided as a nominal guide only. To determine achievable distances, refer to the device's optical specifications and to the specific characteristics of your fiber installation.
Extreme Networks‘ CFP2 optical module form factor, optical/electrical connection, and digital diagnostic interface are designed according to IEEE 802.3ba standards.
Mechanical dimensions, connecters, and footprint of the module conform to the CFP MSA CFP2 Hardware Specification Revision 1.0 July 31, 2013 standard.
This module is a Class 1M laser device.
The following table lists specifications for the CFP2 LR4 module.
| Parameter | Minimum | Typical | Maximum |
|---|---|---|---|
| Transmitter | |||
| Average Output Power in OMA | -1.3 dBm | NA | 4.5 dBm |
| Center wavelength | 1295 nm | NA | 1310 nm |
| Receiver | |||
| Receiver sensitivity in OMA | -8.6 dBm | NA | 4.5 dBm |
| Average receive power (max), each lane | NA | NA | 4.5 dBm |
| Operating wavelength | 1295 nm | NA | 1310 nm |