Configuring FIB compression

Enter hardware configuration mode.

device# config
device(config)# hardware
device(config-hardware)#

Enable FIB compression by using the profile route route-enhance command as in the following example for both IPv4 and IPv6 compression.
```
device(config-hardware)# profile route route-enhance v4_fib_comp v6_fib_comp on
```

Confirm the configuration by using the show hw route-info command for an interface.

device# show hw route-info interface 1/2

HW-Route-Info
====================================================

Slot 1

Tower 0
LEM
Total Entries           :750000
95% Threshold           :712500
85% Threshold           :637500
Total In Use            :39 (.000000%)
        IPV4  routes    :39
        IPV6  routes    :0
Status                  :Green

LPM
Total Entries           :350000
95% Threshold           :332500
85% Threshold           :297500
Total In Use            :331 (.000000%)
        IPV4  routes    :156
        IPV6  routes    :175
Status                  :Green