Configuring the Insight Interface for the SLX 9150/9250

Enter global configuration mode.
```
device# configure terminal
```
In global configuration mode, specify a port-channel. You can create a new port-channel or use an existing unconfigured port-channel. The Insight Interface can only be configured on one port-channel
```
device(config)# interface port-channel 50
```
In interface subtype configuration mode, enter the insight enable command.
```
device(config-Port-channel-50)# insight enable
```

Set the port ip-address.

device(config-Port-channel-50)# ip address 10.0.0.1/24

Enable the interface.

device(config-Port-channel-50)# no shutdown

Use the show interface port-channel and the show port-channel commands to confirm the configuration, as in the following example.

device# show interface port-channel 50
Port-channel 50 is up, line protocol is up
Insight mode is enabled
Hardware is AGGREGATE, address is f46e.959f.1af5    
	Current address is f46e.959f.1af5
Interface index (ifindex) is 671088690 (0x28000032)
Minimum number of links to bring Port-channel up is 1
MTU 9216 bytes
LineSpeed Actual     : 10000 Mbit
Allowed Member Speed : 10000 Mbit
Priority Tag disable
Forward LACP PDU: Disable
Route Only: Disabled
Tag-type: 0x8100
Last clearing of show interface counters: 4d18h22m
Queueing strategy: fifo
FEC Mode - Disabled
Receive Statistics:
	0 packets, 0 bytes
	Unicasts: 0, Multicasts: 0, Broadcasts: 0
	64-byte pkts: 0, Over 64-byte pkts: 0, Over 127-byte pkts: 0
	Over 255-byte pkts: 0, Over 511-byte pkts: 0, Over 1023-byte pkts: 0    
	Over 1518-byte pkts(Jumbo): 0    
	Runts: 0, Jabbers: 0, CRC: 0, Overruns: 0    
	Errors: 0, Discards: 0
Transmit Statistics:    
	12 packets, 5589 bytes    
	Unicasts: 0, Multicasts: 12, Broadcasts: 0    
	Underruns: 0    
	Errors: 0, Discards: 0
Rate info:    
	Input 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate    
	Output 0.000000 Mbits/sec, 0 packets/sec, 0.00% of line-rate
Route-Only Packets Dropped: 0
Time since last interface status change: 00:00:25