Add a Management Access RuleNEW!

Use the Management Access Rules to define the IP addresses and ranges that allow or deny access to management plane services using L3 controller addresses.

To add a new Management Access Rule, select Add New Rule.

Table 1. Management Access Rules Settings
Field	Description
Order	Rules are listed in order of priority. The higher priority rules are listed first.
Action	Indicates whether the rule is to Allow access or Deny access.
Protocol	Indicates TCP, UDP, or ICMP.
Source IP/Subnet	The source IP address and the subnet.
Ports	The port the rule applies to. For a single port, the port number only is displayed, "22". For a range of ports, the lowest and highest included ports are displayed, "20 to 30".
Type	The port type.
Delete	Select to delete the corresponding rule.
Set Priority	Select the up or down arrows to change the priority of the rule.