Create Date/Time filters to display entries that were logged within a specific window of
time. To set a date and time filter for an ExtremeCloud IQ
Controller:
-
Go to .
-
To display the Start Date/Time dialog, select
Change.
-
From the Time field, specify the hour
and minutes and select AM or PM.
-
To set both the start and end dates, in
the Date field, use the arrows to navigate to the month, then select the calendar day for
the start date. Repeat to select the end date.
-
Select OK.
Entries that occur between the start and end date
display. The filtered list will persist during your session. You can navigate away from the
page and return to the same filtered list. However, the filter is cleared after you log out or
reboot the controller.
