This command configures a reload delay on Multi-switch Link Aggregation Group (MLAG) ports.
| reload-delay | Specifies creating a reload delay on MLAG ports. |
| reload-delay | Specifies the MLAG port reload-delay timer in seconds (range = 1–1,200 seconds). The default is 30 seconds. |
The default reload-delay timer interval is 30 seconds.
There are cases where MLAG ports comes up quicker than ISC ports after a switch reboot causing traffic loss during this time gap. This command allows you to configure a time delay for MLAG ports providing enough time for ISC ports/neighborship of other Layer 3 protocols to come up. To have this delay timer take effect, you need to issue the enable mlag port reload-delay command.
The following example sets the reload-delay to 60 seconds:
# configure mlag ports reload-delay 60
This command was first available in ExtremeXOS 22.3.
This command is available on the ExtremeSwitching X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, and X870 series switches.