configure diffserv replacement code-point

configure diffserv replacement [{qosprofile} qosprofile | priority priority] code-point code_point

Description

Configures the egress Diffserv replacement mapping for either a QoS profile or an 802.1p priority value.

Syntax Description

qosprofile Specifies a QoS profile.

priority

Specifies an 802.1p priority value to map to a code point.

code_point

Specifies a 6-bit value to be used as the replacement DSCP in the IPv4 or IPv6 header.

Default

N/A.

Usage Guidelines

Note

Note

We recommend that you use the qosprofile qosprofile value to configure this parameter.

Egress packets contain the DSCP assigned to the QoS profile, which can be selected by the 802.1p code point or by an ACL. The default 802.1p priority value to QoS profile to DSCP mapping is shown in the following table.
Table 1. Default QoS Profile-to-802.1p Priority Value-to-Code Point
802.1p Priority Value ExtremeSwitching Series Switches QoS Profile DSCP

0

QP1

0

1

QP1

8

2

QP1

16

3

QP1

24

4

QP1

32

5

QP1

40

6

QP1

48

7

QP8

56

Example

The following command specifies that a code point value of 5 should be used to replace the DiffServ (TOS) bits in packets in QP2:

# configure diffserv replacement qosprofile qp2 code-point 5

History

This command was first available in ExtremeXOS 11.0.

The ports keyword was first available in ExtremeXOS 12.2.2.

Platform Availability

This command is available on the ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, and X870 series switches.