configure tech-support collector report

configure tech-support collector [hostname | ip_address] report [ automatic | manual ]

Description

This command configures the report mode for a collector.

Syntax Description

all Configures report mode for all report collectors.
hostname Configures report mode based on the host name of the collector.
ip_address Configures report mode based on the IPv4 address of the collector.
automatic Automatically reports switch status to the configured collector (Default).
manual Manually reports switch status to the configured collector through the run tech-support report.

Default

Disabled.

If enabled, the automatic collector is the default report setting.

Usage Guidelines

This command configures the report mode for a collector. When you specify all, it configures report mode for all existing collectors, otherwise it configures report mode for a particular collector specified by the hostname, or IP address. When the report mode is set to automatic, the switch automatically attempts to connect to the cloud-hosted collector, and reports the switch status information based on the frequency and data set setting of the collector. Changing the configuration to manual restricts reporting to user initiated mode using the run tech-support command for that collector. When a collector is added, the report mode is set to automatic by default.

Example

The following command example configures the report mode on all existing collectors:

configure tech-support collector all report

History

This command was first available in ExtremeXOS 15.4.

Platform Availability

This command is available on the ExtremeSwitching X435, X440-G2, X450-G2, X460-G2, X465, X590, X620, X670-G2, X690, X695, and X870 series switches.