Configure Dynamic Channel Switching

Enable Dynamic Channel Switching (DCS) to dynamically select and switch channels based on specified criteria.

Go to Configure > Common Objects > Policy > Radio Profiles.
Select an existing radio profile,and then select , or select .
Enable Dynamic Channel Switching.
Select Automatically select and switch channels during specified time interval.
1. In the From field, enter the start time for the interval.
2. In the To field, enter the end time for the interval.
3. In the Do not switch channels if the number of connected clients exceeds field, specify the number of connected clients.
  
  If the number of associated clients is equal to or less than the specified value, and if the AP finds a better channel, it can switch to a new channel. Associated clients lose their connections and must reconnect. If the number of clients exceeds the value, the AP does not switch to a new channel. When a client de-authenticates during the scheduled time range, the AP checks the number of clients against the value. If the number of clients does not exceed the value, the AP switches channels. If the number of clients still exceeds the value, the AP does not change channels.
Select Switch channels anytime if RF interference exceeds the threshold.
1. In the Interference Threshold field, enter the value (%).
2. In the CRC Error Threshold field, enter the value (%).
3. Select Do not switch channels if clients are connected
Select SAVE RADIO PROFILE.