Print this pagePrint this page

Email this topicEmail this topic

View PDFView PDF

Download EPUBDownload EPUB

floor

Profile Config Commands

Sets the floor name where the target device (access point, wireless controller, or service platform using this profile) is physically located. Assigning a building floor name helps in grouping devices within the same general coverage area.

Supported in the following platforms:

  • Access Points — AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

floor <WORD> {<1-4094>}

Parameters

floor <WORD> {<1-4094>}
floor <WORD> {<1-4094>} Sets the floor name where the target device is located
  • <WORD> – Specify the floor name (should not exceed 64 characters in length).
    • <1-4094> – Optional. Configures the floor number from 1 - 4094. The default is 1.

Example

nx9500-6C8809(config-profile-default-rfs4000)#floor fifth

nx9500-6C8809(config-profile-default-rfs4000)#show context
profile rfs4000 default-rfs4000
 bridge vlan 1
  ip igmp snooping
  ip igmp snooping querier
 area Ecospace
 floor fifth
 autoinstall configuration
 autoinstall firmware
--More--
nx9500-6C8809(config-profile-default-rfs4000)#

Related Commands

no Resets the configured floor name and number
Published April 2019prev | next

Email this topicEmail this topic

Print this pagePrint this page