Print this pagePrint this page

Email this topicEmail this topic

View PDFView PDF

Download EPUBDownload EPUB

vlan

Sets the VLAN where traffic from this WLAN is mapped

Supported in the following platforms:

  • Access Points — AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

vlan [<1-4094>|<VLAN-ALIAS-NAME>]

Parameters

vlan [<1-4094>|<VLAN-ALIAS-NAME>]
<1-4094> Sets a WLAN‘s VLAN ID. This command starts a new VLAN assignment for a WLAN index. All prior VLAN settings are erased.

Use this command to assign just one VLAN to the WLAN. Utilizing a single VLAN per WLAN is a more typical deployment scenario than using a VLAN pool.
<VLAN-ALIAS-NAME> Assigns a VLAN alias to the WLAN. The VLAN alias should be pre-existing and configured.

A VLAN alias maps a name to a VLAN ID. When applied to ports (for example GE ports) using the trunk mode, a VLAN alias denies or permits traffic, on the port, to and from the VLANs specified in the alias. For more information on aliases, see alias.

Examples

nx9500-6C8809(config-wlan-test)#vlan 4
nx9500-6C8809(config-wlan-test)#show context
wlan test
 ssid testWLAN1
 vlan 4
 bridging-mode local
 encryption-type none
 authentication-type none
 protected-mgmt-frames mandatory
 radius vlan-assignment
 time-based-access days weekdays start 10:00 end 16:30
 wing-extensions wmm-load-information
 client-load-balancing probe-req-intvl 5ghz 5
 client-load-balancing band-discovery-intvl 2
 use aaa-policy test
 use association-acl-policy test
 acl exceed-rate wireless-client-denied-traffic 20 disassociate
 proxy-arp-mode strict
 broadcast-dhcp validate-offer
 shutdown on-unadoption
 http-analyze controller
nx9500-6C8809(config-wlan-test)#

Related Commands

no (wlan-config-mode) Removes a WLAN‘s default VLAN mapping
Published April 2019prev | next

Email this topicEmail this topic

Print this pagePrint this page