power
interface-config-radio-instance
Configures the selected radio‘s
transmit power. Use this command to manually set the transmit power
of the selected radio, or select the smart mode by which the
transmit power is determined.
Supported in the
following platforms:
- Access Points —
AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161,
AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622,
AP763, AP7662, AP8163, AP8543, AP8533
Syntax
Parameters
power [<1-30>|smart]
| power |
Configures the
selected radio‘s transmit power |
| <1-30> |
Configures the
transmit power from 1 - 30 dBm (actual power could be lower based on
regulatory restrictions) For
APs with dual or three radios, use this option to manually configure each
radio with a unique transmit power in respect to its intended client
support function.
|
| smart |
Enables Smart RF
to determine the optimum transmit power needed. Use this option to let Smart
RF determine the selected radio's transmit power. If you are using this
option for RF management, ensure that a Smart RF policy is configured and
applied to the AP's RF Domain context. You can also use the default Smart RF
policy. Note: By default,
APs use Smart RF to determine transmit power.
|
|
Examples
nx9500-6C8809(config-profile-510TestProfile-if-radio1)#power 12
nx9500-6C8809(config-profile-510TestProfile-if-radio1)#show context
interface radio1
power 12
data-rates b-only
placement outdoor
mesh client
off-channel-scan channel-list 2.4GHz 1
guard-interval long
aggregation ampdu tx-only
aeroscout forward
ekahau forward ip 172.16.10.1 port 3
non-unicast tx-rate bss 1 dynamic-all
non-unicast tx-rate bss 2 highest-basic
non-unicast tx-rate bss 3 highest-basic
non-unicast tx-rate bss 4 highest-basic
non-unicast tx-rate bss 5 highest-basic
non-unicast tx-rate bss 6 highest-basic
non-unicast tx-rate bss 7 highest-basic
--More--
nx9500-6C8809(config-profile-510TestProfile-if-radio1)#
Print
this page
Email this topic
Feedback
View PDF
Download EPUB