Print this pagePrint this page

Email this topicEmail this topic

View PDFView PDF

Download EPUBDownload EPUB

management-server

Profile Config Commands

Configures a management server with this profile. This command is also applicable to the device configuration context.

Supported in the following platforms:

  • Access Points — AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502, AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662, AP8163, AP8543, AP8533.
  • Service Platforms — NX5500, NX7500, NX9500, NX9600, VX9000

Syntax

management-server <HOST-NAME> port <1-65535>

Parameters

management-server <HOST-NAME> port <1-65535>
management-server <HOST-NAME> port <1-65535> Configures a management server with this profile. Use this command to identify the management server.
  • <HOST-NAME> – Specify the management server‘s host name.
    • port <1-65535> – Specify the port where the management server is reachable. The default setting is port 443.
Note: If the adoption-mode, on this profile, is set to ‘cloud‘, ensure that the management-server configuration points to the ExtremeCloud Web address. If the adoption-mode is set to ‘ws-controller‘, provide the ESE controller‘s IP address or hostname as the management server. For information on configuring the adoption-mode, see adoption-mode.

Example

nx9500-6C8809(config-profile-testRFS4000)#management-server nx9500-6C8809 port 300

nx9500-6C8809(config-profile-testRFS4000)#show context include-factory | include management-server
 management-server nx9500-6C8809 port 300
nx9500-6C8809(config-profile-testRFS4000)#

Related Commands

no Removes the management server configuration
Published April 2019prev | next

Email this topicEmail this topic

Print this pagePrint this page