preempt
Enables preemption of secondary tunnel, in case the primary tunnel goes down. This command
also configures the delay time in preemption of the secondary tunnel.
Use this command to configure the time to wait before preempting the secondary tunnel.
Supported in the following platforms:
- Access Points —
AP505i, AP510i, AP510e, AP560i, AP6522, AP6562, AP7161, AP7502,
AP7522, AP7532, AP7562, AP7602, AP7612, AP7622, AP763, AP7662,
AP8163, AP8543, AP8533.
- Service Platforms
— NX5500, NX7500, NX9500, NX9600, VX9000
Syntax
preemption delay <60-600>
Parameters
preemption delay <60-600>
| preemption delay <60-600> |
When the primary L2TPv3 tunnel goes down, the system waits and watches for the
tunnel to come back, for a specified time, before preempting the secondary tunnel.
Use this command to configure that time period.
- delay <60-600> – Specify
a value from 60 - 600 seconds. The default is 60 seconds.
|
|
Examples
nx9500-6C8809(config-profile test-l2tpv3-tunnel-tunnel1)#preemption delay 100
nx9500-6C8809(config-profile test-l2tpv3-tunnel-tunnel1)#show context
l2tpv3 tunnel tunnel1
preempt enable
preemption delay 100
nx9500-6C8809(config-profile test-l2tpv3-tunnel-tunnel1)#
Print
this page
Email this topic
Feedback
View PDF
Download EPUB