The following table summarizes the User Exec Configuration Mode commands:
User Exec Mode Commands
|
Command |
Description |
|---|---|
| captive-portal-page-upload |
Uploads captive portal advanced pages |
| change-password |
Changes the password of a logged user |
| clear |
Resets the last saved command |
| clock |
Configures the system clock |
| cluster |
Accesses the cluster context |
| commit |
Commits changes made in the active session. |
| connect |
Establishes a console connection to a remote device |
| create-cluster |
Creates a new cluster on a specified device |
| crypto |
Enables encryption |
| crypto-cmp-cert-update | Triggers a CMP certificate update on a specified device or devices |
| database | Enables automatic repairing (vacuuming) and dropping of databases (Captive-portal and NSight) |
| database-backup | Backs up captive-portal and/or NSight database to a specified location and file on an FTP or SFTP server |
| database-restore | Restores a previously exported database [captive-portal and/or NSight]. Previously exported databases (backed up to a specified FTP or SFTP server) are restored to the original database. |
| device-upgrade |
Configures device firmware upgrade settings |
| enable |
Turns on (enables) the privileged mode command set |
| join-cluster |
Adds a device (access point, wireless controller, or service platform) to an existing cluster of devices |
| file-sync | Configures parameters enabling syncing of PKCS#12 and wireless-bridge certificate between the staging-controller and adopted access points |
| help | Describes the interactive help system. |
| l2tpv3 |
Establishes or brings down L2TPv3 (Layer 2 Tunneling Protocol Version 3) tunnels |
| logging |
Modifies message logging facilities |
| mint |
Configures MiNT protocol |
| no |
Negates a command or sets its default |
| on | Executes the following commands in the RF Domain context: clrscr, do, end, exit, help, service, and show |
| opendns | Connects to the OpenDNS site using OpenDNS registered credentials (username, password) OR OpenDNS API token to fetch the OpenDNS device_id. This command is a part of the process integrating access points, controllers, and service platforms with OpenDNS. |
| page |
Toggles a device's (Access Point, wireless controller, or service platform) paging function |
| ping |
Sends ICMP echo messages to a user-specified location |
| ping6 | Sends ICMPv6 echo messages to a user-specified location |
| ssh |
Opens an SSH connection between two network devices |
| telnet |
Opens a Telnet session |
| terminal |
Sets the length and width of the terminal window |
| time-it |
Verifies the time taken by a particular command between request and response |
| traceroute |
Traces the route to its defined IPv4 destination |
| traceroute6 |
the route to its defined IPv6 destination |
| watch |
Repeats a specific CLI command at a periodic interval |
| virtual-machine |
Installs, configures, and monitors the status of VMs (virtual machines). This command is specific to the NX 9500 and NX 9510 series service platforms. |
| exit |
Ends the current CLI session and closes the session window |
Note
For more information on common commands (clrscr, commit, help, revert, service, show, write, and exit), see Common Commands.Note
The input parameter <HOSTNAME>, if used in syntaxes across this chapter, cannot include an underscore (_) character.
Print
this page
Email this topic
Feedback
View PDF
Download EPUB