Configure Channel Selection

Use this section to make changes to the device channel width. The available settings depend on the Supported Radio Mode you selected in the basic configuration section.

Note

Extreme Networks provides defaults for each item in this section. The following steps are optional.

Go to Configure > Common Objects > Policy > Radio Profiles.
Create and save a new radio profile, or select an existing radio profile and then select .
Select a channel from the Channel drop-down list.
Specify the Channel Width and Exclusions.
1. To customize the display, select and clear the check boxes as desired:
  - Show UNII Groups
  - Show Frequency Markers
  - Show Primary Channels
  - Show Preferred Scan Channels (PSC)
To manually exclude channels, select a specific channel.
To manually set Transmission Power, select Manual and then use the slider to select a dBm setting.
Enable Enable client transmission power control (802.11h).
To manually enable client transmission power control (802.11h), use the slider to select a dBm setting.
Enable Limit Channel Selection to limit channel selection to non-overlapping channels.
1. Select the operating Region for the device from the drop-down list.
2. For Channel Model, select 3 channels for USA and 4 channels for Europe.
3. For Limit Channel Selection, USA defaults are 1, 6, and 11, and European defaults are 1, 5, 9.
Enable Use the last known power and channel during the AP boot up process.