Update Netdump Settings

You can configure a device to automatically save a core netdump file to a TFTP server on the network when it next boots up after becoming unresponsive. You can then provide this file to Support to help Extreme Networks diagnose the issue.

  1. Select the devices for this netdump.
  2. Select Actions > Advanced > Update Netdump Settings.
  3. Select Enable Netdump.
  4. Complete the following fields:
    • TFTP server for saving Netdump files: Enter the TFTP server IP address to which you want the devices to send the core dump file.
    • Netdump filename to save: Enter a Netdump filename.
    • VLAN for reaching the TFTP server: Enter the VLAN of the interface from which the device sends the Netdump file to the TFTP server.
    • Native VLAN of the local Extreme Networks device: Enter the native VLAN of the device.
    • DHCP: Select to have the device bootloader use DHCP to obtain an address on startup.
    • Static: Select to have the device bootloader use a static IP address. Enter the required static IP settings that the bootloader must use to connect to the network.
  5. Select Save.
Note

Note

This feature becomes active after you perform a full configuration update for the selected devices.