Network AllocationNEW!

Network Allocation allows the creation of IP subnetwork configuration. A subnetwork with a selected VLAN can be applied to a device within the Routing section.

Note

A VLAN defined within Instant Port Profiles as Non-Forwarding cannot be used to create a subnetwork.

On the Network Allocation page, you can add, edit, or delete Network Allocation configurations. The table includes the following parameters:

Name
Description
IPv4 Subnetwork
Clients Per Subnet
DHCP Relay
VLAN Name
VLAN ID
VLAN Used By

To configure Network Allocation:

Go to Configure > Network Policies.
Create or select a Network Policy.
Select Switching > Routing > Network Allocation.
Select to add or to edit.

Enter the IPv4 Network Allocation Attributes according to the table below:

Table 1. Network Allocation Attributes
Field	Description
VLAN Attribute	A VLAN attribute can be created from within the VLAN attribute section within the Network Policy Switching Section.
Name	The name of your subnetwork.
Description	A description of your subnetwork.
Local IP Address Space	Define the local IP address space using CIDR notation, such as `10.1.0.0/16`.
Clients Per Subnet	Shows the clients per subnet.
Select One	Use the first IP address of the local IP address space for the IPv4 interface Use the last IP address of the local IP address space for the IPv4 interface
Enable DHCP Relay	Enable DHCP Relay. If enabled, select or create a DHCP Relay Common Object.