You can permanently remove bridge port extenders (BPEs) from existing Extended Edge
Switching cascades.
To remove a BPE:
Unconfigure the BPE to be
removed, and all BPEs below the location of that BPE in the cascade starting
from the bottom, and then moving up, using the command:
unconfigure vpexportsport_listslot
Disconnect the desired BPE, and
then re-cable the remaining BPEs as needed.
Re-configure all of the
previously unconfigured BPEs, except for the removed BPE, starting from the top,
and then moving down, using the procedure in Manually Configuring Bridge Port Extenders starting with step 3.
Unconfigure the removed BPE's
slot assignment using the following command:
