To configure PIM multicast routing, enable multicast forwarding as
described in Enabling Multicast Forwarding and do
the following:
-
Configure PIM on all IP multicast routing interfaces using
the following command:
configure pim {ipv4 | ipv6} add vlan [vlan-name | all] {dense | sparse} {passive}
-
To enable and configure the PIM-DM state refresh feature
on one or all VLANs, use the following commands:
configure pim {ipv4 | ipv6} state-refresh {vlan} [vlan_name | all] [on | off]
configure pim { ipv4 |
ipv6 } state-refresh timer origination-interval interval
configure pim {ipv4 | ipv6} state-refresh timer source-active-timer interval
configure pim {ipv4 | ipv6} state-refresh ttl ttlvalue
-
For PIM-SSM, specify the PIM-SSM range, enable IGMPv3,
and enable PIM-SSM on the interfaces using the following commands:
configure pim {ipv4 | ipv6} ssm range [default | policy
policy-name]
enable igmp {vlan
vlan name } {IGMPv1 | IGMPv2 | IGMPv3}
enable pim {ipv4 | ipv6} ssm vlan [vlan_name | all]
-
Enable PIM on the router using the following
command:
enable pim
