Auto provisioning is enabled by default. It can be
restarted by clearing the switches configuration using unconfigure switch {all | erase [all | nvram]} with the
all and rebooting the switch.
Note
Auto provisioning is not enabled on the
VLAN
(Mgmt or Default) if the IP address is already configured.
To disable auto provision, use the following
command:
disable
auto-provision
When the disable auto-provision command is issued, the
following message is displayed:
This setting
will take effect at the next reboot of this switch.
To display the current state of auto provision on the
switch, use the following command:
