We recommend that you keep the loop protection warning messages enabled.
If you have considerable knowledge and experience with EAPS,
you might find the EAPS loop protection warning messages unnecessary.
-
To enable the EAPS function for the
entire switch, use the following command:
enable eaps
-
To disable the EAPS function for the
entire switch, use the following command:
disable eaps
If you enter the command to
disable EAPS, the default switch configuration displays the following warning message and
prompts you to confirm the
command:
WARNING: Disabling EAPS on the switch could cause a loop in the network! Are you sure you want to disable EAPS? (y/n)
-
When prompted, do one of the following:
-
Enter y to disable EAPS for the
entire switch.
-
Enter n or press [Return] to cancel the command.
