-
To create an MLAG peer switch association structure, use
the following command:
create mlag peer peer_name
-
To delete a peer switch, use the following command:
delete mlag peer peer_name
-
To associate an MLAG peer structure with an MLAG peer
switch IP address, use the following command:
configure mlag peer peer_name
ipaddress
peer_ip_address {vr
VR}
-
To unconfigure the association, use the following
command:
unconfigure mlag peer peer_name
ipaddress
-
To configure the time interval between health check hello
packets exchanged between MLAG peer switches, use the following command:
configure mlag peer peer_name
interval
msec
-
To unconfigure the time interval setting and reset the
interval to the default of 1000 ms, use the following command:
unconfigure mlag peer peer_name
interval
-
To bind a local port or LAG to an MLAG specified with an integer
identifier, use the following command:
enable mlag port port
peer
peer_name
id
identifier
-
To disable a local port or LAG from an MLAG, use the
following command:
disable mlag port port
-
To enable the current ports associated
with the given MLAG ID, use the following command:
enable ports [mlag-id
mlag_id]
-
To disable the current ports associated
with the given MLAG ID, use the following command:
disable ports [mlag-id
mlag_id]
-
To set a preference for having a fast convergence time or
conserving access lists, use the following command:
configure mlag ports convergence-control [conserve-access-lists | fast]
Note
Executing the
refresh policy command with MLAG configuration
may result in health check hellos not reaching the CPU. To avoid MLAG peer connectivity
disruption, you can either execute the
disable
access-list refresh blackhole command or temporarily increase the peer hello
interval to a large value (for instance, 10000 ms) and reset it back once refresh policy
is complete.
-
To enable or disable MLAG linkup isolation, use the
following command:
configure mlag ports link-up-isolation [on | off]
-
To start orchestration mode, use the following command:
start orchestration
mlag
peer_name
-
To stop orchestration mode, use the following command:
stop {orchestration}
-
To configure MLAG reload delay timer, use the following command:
configure mlag ports
reload-delay
reload-delay
-
To enable MLAG reload delay timer, use the following command:
enable mlag port reload-delay
-
To disable MLAG reload delay timer, use the following command:
disable mlag port reload-delay
-
To view the configured MLAG reload delay timer setting, use the following
command:
show mlag ports {port_list}
-
To rename an existing MLAG peer, use the following command:
configure { mlag peer } peer_name
name
new_peer_name
