Configure Tunnel Concentrator Service

Use this procedure on Extreme Platform ONE Networking to configure a Tunnel Concentrator Service that includes either a single Tunnel Concentrator instance or an HA pair of instances.
Note

Note

For detailed field descriptions, see Tunnel Concentrator Service Settings.
  1. On Extreme Platform ONE Networking, select Network Policies, then select Menu > Common Objects > Network > Tunnel Concentrator Services.
  2. Select an existing service or select (Add) to create a new service.
  3. Enter a Name for the service.
  4. Select the type of Tunnel Concentrator service:
    • Single Tunnel Concentrator—A service with a single instance.
    • Redundant Tunnel Concentrator—A service with a pair of instances for HA.
  5. Optional. Select Secure connection (IPsec) if you want encrypted tunneling.
  6. For Tunnel IP Address/CIDR, enter the IP address and network mask that terminates the tunnel.
  7. Optional. For Gateway, enter the address of the default gateway.
  8. HA only. Enter the VRRP Router ID.
  9. For Native VLAN, enter a VLAN ID.
  10. Complete the following fields with details for each Tunnel Concentrator instance. If you are configuring redundancy, complete these fields separately for both instances:
    • Device Tunnel Concentrator—Select the Tunnel Concentrator instance that you want to apply to this role.
    • Tunnel Port—Enter the port for tunnel termination.
    • VLAN ID—Enter the VLAN ID for this instance.
    • IP Address (HA only)—Enter the IP address of the tunnel termination point for this instance.
    • Bridge Port—Select the bridge port for this instance.
  11. Configure keepalive settings for this Tunnel Concentrator service:
    • AP Keepalive Interval (seconds)—Set the keepalive interval for the sending of keepalives to tunnels that aren't being used.
    • AP Keepalive Retries—Set the maximum number of times that the AP resends a failed keepalive before setting the tunnel status to Inactive.
  12. Optional. To provision an IP address pool for clients that connect to this tunnel, select Tunnel Concentrator Address Pool and configure the following fields to define the range:
    • Address Pool Profile Name—A name for the pool.
    • Tunnel Concentrator Address Pool Start—The starting IP address.
    • Tunnel Concentrator Address Pool End—The ending IP address.
    • Tunnel Concentrator Address Netmask—The netmask for the range.
    • Tunnel Concentrator Address Next Hop—The next hop router.
  13. Select Save.
  14. Repeat this procedure if you want to configure additional Tunnel Concentrator services.