Displaying SNMP Settings

To view SNMP (Simple Network Management Protocol) settings configured on the switch, use the following command:

show management

This command displays the following information:

Enable/disable state for Telnet and SNMP access
Login statistics
Enable/disable state for idle timeouts
Maximum number of CLI sessions
SNMP community strings
SNMP notification type (trap or INFORM)
SNMP trap receiver list
SNMP trap receiver source IP address
SNMP statistics counter
SSH access states of enabled, disabled, and module not loaded
CLI configuration logging
SNMP access states of v1, v2c disabled and v3 enabled
Enable/disable state for Remote Monitoring (RMON)
Access-profile usage configured via ACLs for additional Telnet, SSH2 security, SNMP, and HTTP(s)
CLI scripting settings
Enable/disable state
Error message setting
Persistence mode
Dropped SNMP packet counter

Published March 2020prev | next