Creating and Deleting VRFs

Before you delete a VRF, you must delete all VLANs and stop all protocols that are assigned to that VRF. All of the ports assigned to a deleted VRF are deleted and made available to assign to other VRs and VRFs. Any routing protocol instance that is assigned to the VRF is deleted gracefully.

To create a VRF, use the following command and include the type attribute:
create virtual-router name {type [vrf | vpn-vrf {vr parent_vr_name}]}

Note
VRFs are supported only on the platforms listed for this feature in the ExtremeXOS 22.3 Feature License Requirements document. To support a Layer 3 VPN, a VPN VRF must be created under the parent VR that will run the MPLS (Multiprotocol Label Switching) protocol.

A VRF name cannot have the same name as a VLAN or VR.
To display the VRFs, use the following command:
show virtual-router {name}
To delete a VRF, use the following command:
delete virtual-router {name}

Published March 2020prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback