ESRP Ping Tracking

You can configure ESRP (Extreme Standby Router Protocol) to track connectivity using a simple ping to any IPv4 device. This may represent the default route of the switch, or any device meaningful to network connectivity of the master ESRP switch. The switch automatically relinquishes master status and remains in slave mode if a ping keepalive fails. You can configure a maximum of eight ping tracks.

Note

ESRP ping tracking is not supported for IPv6 destinations. The ESRP ping tracking option cannot be configured to ping an IP address within an ESRP VLAN (Virtual LAN) subnet. It should be configured on some other normal VLAN across the router boundary.

To configure ping tracking, use the following command:

configure esrp esrpDomain add track-ping ipaddress frequency seconds miss misses

The seconds parameter specifies the number of seconds between ping requests. The range is one to 600 seconds.

The misses parameter specifies the number of consecutive ping failures that will initiate failover to an ESRP slave. The range is one to 256 pings.
To disable ping tracking, use the following command:

configure esrp esrpDomain delete track-ping ipaddress

Published March 2020prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback