Note
Tracert might not always work if inter-VRF routing is configured in one of the hops to the destination.Note
When inter-vr routing is configured the gateway address should be different from VLAN (Virtual LAN) IP of the switch and it should be reachable (ARP resolved) from the switch.The gateway address cannot be loop back address or any local address. A static route's next-hop (gateway) must be associated with a valid IP subnet and cannot use the same IP address as a local VLAN. An IP subnet is associated with a single VLAN by its IP address and subnet mask. If the VLAN is subsequently deleted, the static route entries using that subnet must be deleted manually.
For Inter-VR routing, the egress VLAN name specified in the static route command may be a VLAN belonging to a VR different from the VR of the static route itself. When the VRs differ, Inter-VR routing of hardware and software forwarded packets is performed. This command can enable or disable BFD protection for one static route. However, this protection is not provided until the BFD client is enabled at each end of the route with the following command:
Print
this page
Email this topic
Feedback
View PDF
Download EPUB