Viewing CLI Scripting Status

The show management command displays whether or not CLI scripting is enabled, whether or not the configuration is persistent, and the CLI scripting error mode as shown in the following example:

show management
switch # show management
CLI idle timeout                 : Enabled (20 minutes)
CLI max number of login attempts : 5
CLI max number of sessions       : 16
CLI paging                       : Enabled (this session only)
CLI space-completion             : Disabled (this session only)
CLI configuration logging        : Disabled
CLI scripting                    : Disabled (this session only)
CLI scripting error mode         : Ignore-Error (this session only)
CLI persistent mode              : Persistent (this session only)
CLI prompting                    : Enabled (this session only)
Telnet access                    : Enabled (tcp port 23 vr all)
: Access Profile : not set
SSH Access                       : ssh module not loaded.
Web access                       : Enabled (tcp port 80)
Total Read Only Communities      : 1
Total Read Write Communities     : 1
RMON                             : Disabled
SNMP access                      : Enabled
: Access Profile Name : not set
SNMP Traps                       : Enabled
SNMP v1/v2c TrapReceivers        :
Destination         Source IP Address     Flags
10.255.43.38 /10550                        2E
10.255.43.11 /10550                        2E
10.255.99.13 /10550                        2E
10.255.57.2 /10550                        2E
10.255.43.15 /10550                        2E
10.255.42.81 /10550                        2E
Flags:  Version: 1=v1 2=v2c
Mode: S=Standard E=Enhanced
SNMP stats:     InPkts 0       OutPkts   6       Errors 0       AuthErrors 0
Gets   0       GetNexts  0       Sets   0       Drops      0
SNMP traps:     Sent   6       AuthTraps Enabled