Traceroute

The traceroute command enables you to trace the path between the switch and a destination endstation.

traceroute {vr vrid} {ipv4 host} {ipv6 host} {ttl number} {from from} {[port port] | icmp}
vr The name of the virtual router (VR).
ipv4/ipv6 The transport.
from Uses the specified source address in the ICMP (Internet Control Message Protocol) packet. If not specified, the address of the transmitting interface is used.
host The host of the destination endstation. To use the hostname, you must first configure DNS.
ttl Configures the switch to trace the hops until the time-to-live has been exceeded for the switch.
port Uses the specified UDP port number.
icmp Uses ICMP echo messages to trace the routed path.