Guidelines for Configuring VMANs

The following are VMAN configuration guidelines for all platforms:

Duplicate customer MAC addresses that ingress from multiple VMAN access ports on the same VMAN can disrupt the port learning association process in the switch.
VMAN names must conform to the guidelines described in Object Names.
You must use mutually exclusive names for:
- VLAN (Virtual LAN)s
- VMANs
- IPv6 tunnels
VMAN ports can belong to load-sharing groups.

You can enable or disable jumbo frames before configuring VMANs. You can enable or disable jumbo frames on individual ports. See Configuring Ports on a Switch for more information on configuring jumbo frames.
STP (Spanning Tree Protocol) operation on CVLAN components in a PEB as described in IEEE 802.1ad is not supported.
The initial version of this feature does not implement an XML API.
Multiple VMAN roles can be combined on one port with certain VLAN types as shown in Port Support for Combined VMAN Roles and VLANs.

Port Support for Combined VMAN Roles and VLANs

Platform	Combined CNP, CEP, and Tagged VLAN^a^,^b	Combined PNP, CNP, and CEP ^a^,^b^,^c	Combined PNP and Tagged VLAN	Combined PNP and Untagged VLAN
Summit X460-G2, X670-G2, and X770	X	X	X ^d	X

Note

If you already configured VLANs and VMANs on the same stand-alone switch using ExtremeXOS 11.4 or later, you cannot change the VMAN ethertype from 0X8100 without first removing either the VLAN or VMAN configuration.

Published March 2020prev | next

Email this topic

Print this page Print this page

Leave feedback Feedback