Print this pagePrint this page

Email this topicEmail this topic

View PDFView PDF

Download EPUBDownload EPUB

Hardware Forwarding Limitations

Summit family switches can use hardware forwarding when the route mask is 64 bits or less. If the route mask is greater that 64 bits, limitations apply based on the hardware platform.

This support was added in ExtremeXOS Release 12.4 by using some of the slices previously used for ACL (Access Control List) support to create a Greater Than 64 Bit (GT64B) table. The GT64B table stores only those routes with a mask greater than 64 bits. When IPv6 forwarding is enabled, the switch behavior is as follows:

  • Fewer slices are available for ACLs.

    Use show access-list usage acl-slice to check if any slice is unused. If no slice is available, consider disabling a feature that is consuming ACL slices if that feature is not required. Features that are enabled by default such as IGMP (Internet Group Management Protocol) Snooping or MLD Snooping can be disabled to free up ACL resources if not required.

  • Table-full messages appear when there is no more space in the GT64B table.
  • If an eligible route cannot be added to the GT64B table (because the table is full), there is no guarantee that traffic for that route will be properly routed.
  • If enabled, route compression for IPv6 can make room for additional routes by reducing the number of entries in the GT64B table.
  • When an IPv6 address with a mask greater that 64 bits is configured on a VLAN (Virtual LAN) or tunnel, that address is automatically added to the GT64B table.

All Summit switches support hardware forwarding for up to 256 routes with masks greater than 64 bits.

This support was added in ExtremeXOS Release 12.4 by using a hardware table designed for this purpose. When IPv6 forwarding is enabled, the switch behavior is as follows:
  • If no space is available in the hardware table, there is no guarantee that traffic for that route will be properly routed.
  • If enabled, route compression for IPv6 can make room for additional routes by reducing the number of entries in the hardware table.
  • When an IPv6 address with a mask greater that 64 bits is configured on a VLAN or tunnel, that address is automatically added to the hardware table.
Published March 2020prev | next

Email this topicEmail this topic

Print this pagePrint this page