To display the OSPF route information for a specified VRF, enter the following command at any level of the CLI.
device# show ip ospf vrf green routes
OSPF Area 0x00000001 ASBR Routes 2:
Destination Mask Path_Cost Type2_Cost Path_Type
10.2.10.2 10.255.255.255 1 0 Intra
Adv_Router Link_State Dest_Type State Tag Flags
10.2.10.2 10.2.10.2 Asbr Valid 0 0000
Paths Out_Port Next_Hop Type State
1 6/3 192.168.201.2 OSPF 00 00
In this example, four routes have been redistributed from BGP routes.
Syntax: show ip ospf vrf vrf-name routes [ ip-addr ]
The vrf-name parameter specifies the VRF that the user wants to display OSPF routes for.
The ip-addr parameter specifies a destination IP address. When the user uses this parameter, only the route entries for that destination are shown.