show ip vrrp interface
Display Virtual Router Redundancy Protocol (VRRP) information about the interface.
Syntax
-
show ip vrrp interface
-
show ip vrrp interface
-
show ip vrrp interface
[versin <2-3>]
-
show ip vrrp interface
[version <2-3>]
-
show ip vrrp interface
verbose
-
show ip vrrp interface vrf
WORD<1-16>
-
show ip vrrp interface
vrfids WORD<0-512>
-
show ip vrrp interface
vrid <1-255>
Command Parameters
- [version <2|3>
- Displays the VRRP version
configured.
- gigabitEthernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
- Identifies the slot and port in
one of the following formats: a single slot and port (slot/port), a range of slots
and ports (slot/port-slot/port), or a series of slots and ports
(slot/port,slot/port,slot/port). If your platform supports channelization and the
port is channelized, you must also specify the sub-port in the format
slot/port/sub-port.
- verbose
- Shows all available information
about the VRRP interfaces.
- vlan <1-4059>
- Shows the VRRP interface
gigabitEthernet configurations. Specifies the VLAN ID in the range of 1 to 4059.
By default, VLAN IDs 1 to 4059 are configurable and the system reserves VLAN IDs
4060 to 4094 for internal use. If you enable VRF scaling and SPBM mode, the system
also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the default VLAN and you cannot
create or delete VLAN ID 1.
- vrf WORD<1-16>
- Shows all available information
about the VRRP interfaces.
- vrfids WORD<0-512>
- Specifies the ID of the VRF.
