spanning-tree rstp port

Syntax

• default spanning-tree rstp

• default spanning-tree rstp

• default spanning-tree rstp port {slot/port[/sub-port]}

• no spanning-tree rstp

• no spanning-tree rstp port {slot/port[/sub-port]}

• spanning-tree rstp port {slot/port[/sub-port]} cost <1-200000000>

• spanning-tree rstp port {slot/port[/sub-port]} edge-port { false | true }

• spanning-tree rstp port {slot/port[/sub-port]} p2p auto

• spanning-tree rstp port {slot/port[/sub-port]} p2p force-false

• spanning-tree rstp port {slot/port[/sub-port]} p2p force-true

• spanning-tree rstp port {slot/port[/sub-port]} priority <0-240>

• spanning-tree rstp port {slot/port[/sub-port]} protocol-migration false

• spanning-tree rstp port {slot/port[/sub-port]} protocol-migration true

• spanning-tree rstp port {slot/port[/sub-port]} stp enable

Command Parameters

cost <1-200000000>

Specifies the cost value. The default is 2000000.

edge-port <false|true>

Enables or disables the port as an edge port. The default is disabled (false).

p2p <auto|force-false|false-true>

A value of force-true indicates that this port is treated as if it connects to a point-to-point link.

A value of force-false indicates that this port is treated as having a shared media connection.

A value of auto indicates that this port is considered to have a point-to-point link if it is an aggregator and all of its members are aggregatable, or if the MAC entity is configured for full-duplex operation, either through autonegotation or by management means.

The default is auto.

port {slot/port[/sub-port]}

Identifies a single slot and port. If the platform supports channelization and the port is channelized, you must also specify the sub-port in the format slot/port/sub-port.

priority <0-240>

Specifies the four most significant bits of the port identifier. The values configured for port priority must be in steps of 16. The default is 128.

protocol-migration <false|true>

Configures the protocol migration state of this port. The default is false.

stp enable

Enables STP for the port. The default is disabled.

Default

None

Command Mode

GigabitEthernet Interface Configuration