filter acl ace policer

Use the policer filter to limit the service and peak rate traffic at the ingress.

Syntax

Command Parameters

<ace-id>

Specifies the ACE ID. Different hardware platforms support different ACE ID ranges. Use the CLI Help to see the available range for the switch.

<acl-id>

Specifies the ACL ID. Use the CLI Help to see the available range for the switch.

policer
Specifies the policer parameters for an ACE.
svc-rate <0-4000000000>
Specifies the rate of transfer of traffic which has to be delivered.
peak-rate <8-4000000000>
Specifies the maximum rate of transfer of traffic above which the packets are dropped at ingress.

Default

None

Command Mode

Global Configuration

9037802-00 Rev AA