show ipv6 address
View IPv6 address entries.
Syntax
-
show ipv6 address
interface
-
show ipv6 address
interface gigabitethernet
[{slot/port[/sub-port][-slot/port[/sub-port]][,...]}]
-
show ipv6 address
interface ip WORD<0-46>
-
show ipv6 address
interface ip WORD<0-46> vrf WORD<1-16>
-
show ipv6 address
interface ip WORD<0-46> vrfids WORD<0-512>
-
show ipv6 address
interface tunnel <1-2000>
-
show ipv6 address
interface vlan [ <1-4059>]
-
show ipv6 address
interface vrf WORD<1-16>
-
show ipv6 address
interface vrfids WORD<0-512>
Command Parameters
- {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
- Identifies the slot and port in
one of the following formats: a single slot and port (slot/port), a range of slots
and ports (slot/port-slot/port), or a series of slots and ports
(slot/port,slot/port,slot/port). If your platform supports channelization and the
port is channelized, you must also specify the sub-port in the format
slot/port/sub-port.
- <1-4059>
- Specifies the VLAN ID in the range
of 1 to 4059. By default, VLAN IDs 1 to 4059 are configurable and the system
reserves VLAN IDs 4060 to 4094 for internal use. If you enable VRF scaling and
SPBM mode, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the
default VLAN and you cannot create or delete VLAN ID 1.
- tunnel <1-2000>
- Displays the address entries
specific to a tunnel ID.
- vrf WORD<1-16>
- Specifies a VRF name. The VRF
parameter is optional.
- vrfids WORD<0-512>
- Specifies a VRF by ID. The VRF
parameter is optional.
- WORD<0-46>
- Specifies an IPv6 address.
