show lacp interface
View Link Aggregation Control Protocol (LACP) statistics for each port to monitor LACP
performance of the port.
Syntax
-
show lacp interface
-
show lacp interface
gigabitethernet
-
show lacp interface
gigabitethernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
-
show lacp interface
gigabitethernet vid <1-4059>
-
show lacp interface mlt
-
show lacp interface mlt
<64-6399>
-
show lacp interface mlt id
<1-512>
Command Parameters
- gigabitethernet {slot/port[/sub-port][-slot/port[/sub-port]][,...]}
- Identifies the slot and port in
one of the following formats: a single slot and port (slot/port), a range of slots
and ports (slot/port-slot/port), or a series of slots and ports
(slot/port,slot/port,slot/port). If your platform supports channelization and the
port is channelized, you must also specify the sub-port in the format
slot/port/sub-port.
- mlt <64-6399>
- Shows the MLT LACP information for
all MLTs or the specific MLT index.
- mlt id <1-512>
- Specifies the MLT ID.
- vid <1-4059>
- Shows only ports attached to a
particular VLAN ID. By default, VLAN IDs 1 to 4059 are configurable and the system
reserves VLAN IDs 4060 to 4094 for internal use. If you enable VRF scaling and
SPBM mode, the system also reserves VLAN IDs 3500 to 3998. VLAN ID 1 is the
default VLAN and you cannot create or delete VLAN ID 1.
