Displays configuration information and statistics for BGP4+ neighbors of the device.
Privileged EXEC mode
Use this command to view configuration information and statistics for BGP4+ neighbors of the device. Output shows all configured parameters for the neighbors. Only the parameters whose values differ from defaults are shown.
device# show ipv6 bgp neighbors
Total number of BGP Neighbors: 1
'+': Data in InQueue '>': Data in OutQueue '-': Clearing
'*': Update Policy 'c': Group change 'p': Group change Pending
'r': Restarting 's': Stale '^': Up before Restart '<': EOR waiting
1 IP Address: 2000::1, AS: 200 (EBGP), RouterID: 20.0.0.1, VRF: default-vrf
State: ESTABLISHED, Time: 2h21m47s, KeepAliveTime: 60, HoldTime: 180
KeepAliveTimer Expire in 49 seconds, HoldTimer Expire in 143 seconds
Minimal Route Advertisement Interval: 0 seconds
PeerGroup: pg
DYNAMIC neighbor belongs to the subnet range group:
2000::/64
Multihop-EBGP: yes, ttl: 1
RefreshCapability: Received
Address Family : VPNV4 Unicast
SendExtendedCommunity: yes
Address Family : VPNV6 Unicast
SendExtendedCommunity: yes
Address Family : L2VPN EVPN
SendCommunity: yes
SendExtendedCommunity: yes
Address Family : IPV4 Flowspec
SendExtendedCommunity: yes
Messages: Open Update KeepAlive Notification Refresh-Req
Sent : 1 0 165 0 0
Received: 1 0 163 0 0
Last Update Time: NLRI Withdraw NLRI Withdraw
Tx: --- --- Rx: --- ---
Last Connection Reset Reason:Unknown
Notification Sent: Unspecified
Notification Received: Unspecified
Neighbor NLRI Negotiation:
Peer Negotiated VPNv4 unicast capability
Peer Negotiated VPNv6 unicast capability
Peer Negotiated L2VPN EVPN address family
Peer Negotiated IPV6 unicast capability
Peer configured for VPNv4 unicast Routes
Peer configured for VPNv6 unicast Routes
Peer configured for L2VPN EVPN address family
Peer configured for IPV6 unicast Routes
Neighbor ipv6 MPLS Label Capability Negotiation:
Neighbor AS4 Capability Negotiation:
Outbound Policy Group:
ID: 4, Use Count: 1
BFD:Disabled
Byte Sent: 3204, Received: 3166
Local host: 2000::2, Local Port: 179
Remote host: 2000::1, Remote Port: 8047
Maintenance Mode : Disabled
G-Shut: Disabled
Remote host: 98.0.0.1, Remote Port: 179