neighbor route-map

Filters the outgoing and incoming route updates to or from a particular BGP neighbor according to a set of attributes defined in a route map.

Syntax

neighbor { ip-address | ipv6-address | peer-group-name } route-map { in string | out string }

no neighbor { ip-address | ipv6-address | peer-group-name } route-map { in string | out string }

Command Default

This feature is disabled.

Parameters

ip-address: IPv4 address of the neighbor
ipv6-address: IPv6 address of the neighbor
peer-group-name: Peer group name configured by the neighbor peer-group-name command.
in: Applies the filter on incoming routes.
string: Name of the route map. Range is from 1 through 63 ASCII characters.
out: Applies the filter on outgoing routes.

Modes

BGP address-family IPv4 unicast configuration mode

BGP address-family IPv6 unicast configuration mode

BGP address-family IPv4 unicast VRF configuration mode

BGP address-family IPv6 unicast VRF configuration mode

BGP address-family L2VPN EVPN configuration mode

Usage Guidelines

The no form of the command restores the defaults.

Examples

The following example applies a route map named "myroutemap" to an outgoing route from 10.11.12.13.

device# configure terminal
device(config)# router bgp
device(config-bgp-router)# address-family ipv4 unicast
device(config-bgp-ipv4u)# neighbor 10.11.12.13 route-map out myroutemap

The following example applies a route map named "myroutemap" to an incoming route from 2001:2018:8192::125.

device# configure terminal
device(config)# router bgp
device(config-bgp-router)# address-family ipv6 unicast
device(config-bgp-ipv6u)# neighbor 2001:2018:8192::125 route-map in myroutemap

The following example applies a route map named "myroutemap" to an outgoing route from 10.11.12.13 in L2VPN EVPN configuration mode.

device# configure terminal
device(config)# router bgp
device(config-bgp-router)# address-family l2vpn evpn
device(config-bgp-evpn)# neighbor 10.11.12.13 route-map out myroutemap