bandwidth-ceiling

This command adds a new threshold change point to the autobw-threshold table. When the change point is already there, the threshold value updates to the new value.

Syntax

bandwidth-ceiling [ bw in kbps | max-bw-threshold [ threshold _n_kbps | [ percentage threshold_percentage ] ]
no bandwidth-ceiling

Command Default

There are no bandwidth ceiling entry.

Parameters

bw_in_kbps
The bandwidth in kilobytes per second. 0 - 0x7FFFFFFF. Range of bandwidth in kbps.
max-bw-threshold theshold _in_kbps
The threshold in kilobytes per second. 0 - 0x7FFFFFFF. Rangeof bandwidthin kbps.
threshold threshold_percentage
The threshold percentage per second. 0 - 100%. By default, the last ceiling is used.
Note

Note

The first parameter indicates that any rate above the maximum ceiling configured. The second parameter is the threshold in kbps. for those rates.

Modes

MPLS global adjustment threshold configuration mode.

Usage Guidelines

Review the updated global adjustment-threshold table after executing this command.

The max keyword sets the threshold for any traffic-rate above the maximum bandwidth-ceiling configured in the table.

The no function of the command remove the bandwidth ceiling entry from the table.

MPLS is supported on Extreme 8820, SLX 9740, SLX 9640, and SLX 9540 devices.

Examples

The following example configures the bandwidth ceiling maximum threshold percentage to 10.

device>configure
device(config)# router mpls
device(config-router-mpls)# autobw-threshold-table
device(config-router-mpls-autobw-threshold-table)# max threshold percentage 10