lsp

Accesses LSP subconfiguration mode to configure the LSP tunnel.

Syntax

lsp name
no lsp name

Parameters

name
Specifies the name of the LSP tunnel.

Modes

MPLS configuration mode

Usage Guidelines

Use the no form of this command to remove the LSP from the MPLS configuration.

MPLS is supported on the Extreme 8820, SLX 9740, SLX 9640, and SLX 9540 devices only.

Examples

The following example configures LSP to2 and accesses LSP subconfiguration mode.

device# configure terminal
device(config)# router mpls
device(config-router-mpls)# lsp to2
device(config-router-mpls-lsp-to2)#