firmware download fullinstall

Downloads the firmware on the local device.

Syntax

firmware download { fullinstall | ftp | scp | sftp | tftp | usb } [ manual ] [ nocommit ] [ noreboot ] [ noactivate ] [ coldboot ] host { hostname | host_ip_address } user username password password directory directory [ file file_name ] [ use-vrf vrf-name] ]

Command Default

By default, firmware download downloads the firmware to the system, reboots the system, and commits the firmware automatically. The user can specify noactivate to download the firmware to the system without activating it (the node is not rebooted). You can run the firmware activate command later to activate the firmware.

Parameters

fullinstall
Downloads a larger file selection to cover the differences between 32-bit and 64-bit firmware when upgrading or downgrading the device.
ftp | scp | sftp | usb
Valid protocols are ftp (File Transfer Protocol), scp (Secure Copy), sftp (SSH File Transfer Protocol), tftp (Trivial File Transfer Protocol), or usb (Universal Serial Bus). The values are not case-sensitive.
manual
Currently, this keyword has no effect.
nocommit
Disables auto-commit mode. When auto-commit mode is disabled, firmware is downloaded only to the primary partition. You must execute the firmware commit command manually to propagate the new image to the secondary partition.
noreboot
Disables auto-reboot mode. When auto-reboot mode is disabled, you must reboot the device manually.
noactivate
Downloads the firmware to the system without activating it, so the device is not automatically rebooted. You can run the firmware activate command later to activate the firmware.
host
Specifies the host by DNS name or IP address.
hostname
Specifies an IPv4 DNS host name.
host_ip_address
Specifies the host IP address. IPv4 and IPv6 addresses are supported.
directory directory
Specifies a fully qualified path to the directory where the firmware is located.
file file_name
Specifies the firmware .plist file. This parameter is optional; if unspecified, the default file, release.plist, is used.
user username
Specifies the user login name for the host.
password password
Specifies the account password.
use-vrf vrf-id

Use this option to specify the name of the VRF where the host is located. If this option is not set, mgmt-vrf is used by default.

Modes

Privileged EXEC mode

Usage Guidelines

Unless you specify noactivate, the upgrade or downgrade involves system reboots that disrupt traffic.

If the firmware download command is interrupted because of an unexpected reboot, such as a result of a software error or power failure, the command automatically recovers the corrupted secondary partition. Wait for the recovery to complete before beginning another firmware download.

The fullinstall option enables upgrading the firmware from a 32-bit version to a 64-bit version. Additionally, the fullinstall option enables downgrading the firmware from a 64-bit version to a 32-bit version. This feature assumes the device hardware is capable of supporting 64-bit architecture.

The fullinstall option preserves startup-config, SSH host keys, and licenses. However, though the startup-config is preserved, the system is designed to boot with the default-config. You must manually apply the configs that were preserved, if configurations are compatible. Manually copying the config file uses the copy flash://startup-config running-config command or the copy <file> running-config command.

It is recommended that you back up your running configuration before running the fullinstall command. Use one of the following commands to do so:

The system then can use the backed up configuration file to restore your configuration during full install.